1. Sterile homogenizer Disconnect the power supply and disconnect the plug if it is not used for a long time. Prevent the aging of electronic components inside the aseptic homogenizer.
2. Do not open the sterile homogenizer door when working on the hammer plate to avoid overflow of the sample liquid. It should be built according to “on/off” and the equipment will stop running automatically. When the aseptic homogenizer door is closed, press “Open/Stop” to build, the equipment will automatically complete the remaining work, and do not reverse the operation!
3. The power plug must be tightly inserted. Looseness may affect the computer controller causing the aseptic homogenizer to crash. If there is a crash, please turn off the rear power switch and restart after 3 minutes of shutdown.
4. The bottom of the aseptic homogenizer door prevents accidental rupture of the homogenized bag, which is convenient for cleaning the spill. The bottom design is empty and the water tray can be placed. Therefore, do not extend the bottom of the aseptic homogenizer by hand. To avoid scratching your fingers. Do not open the sterile homogenizer door when the aseptic homogenizer is working, causing unnecessary losses.
5. Before the machine is running, please check the container of the aseptic homogenizer for foreign matter to avoid malfunction and damage to the homogenized bag during work.
6, hard block, bone, ice and other hard and sharp substances should not use a sterile homogenizer, so as not to damage the homogenized bag.
7. Sterile homogenizers and homogenized bags should be stored in direct sunlight. In particular, homogenized bags should be stored in a place free of sunlight or ultraviolet rays to avoid aging.
8. When the amount is small, when the speed is needed, when the homogenized fiber is tougher, the rear knob can be used to adjust the spacing between the slap plate and the window to achieve a better homogenization effect. Pay attention to the adjusted distance to avoid the occurrence of damage to the sterile aseptic homogenizer.
The correct procedure for using a sterile homogenizer is:
1. Put the sample to be processed into a sterile homogenized bag.
2. Open the sterile homogenizer door and clamp the sterile bag opening when closing the homogenizer door.
3. Set the usage program (such as the slap speed, slap time, etc.) to perform the slap homogenization work.
4. After the experiment is completed, open the sterile homogenizer door and take out the sample.
